Grizzly G7297 User Manual download pdf (Page 13)

G7297 Disc Sander -11-

General

When the table tilt is set to 0˚, the table should be

adjusted perpendicular to the sanding disc face.

To adjust table tilt:

1. Using a try square or machinist’s square, set

one edge on the table surface and the other

against the face of the disc as shown in

Figure 3. Note—This can be done with the

sandpaper installed, although it is somewhat

easier to measure if the disc does not have

the sandpaper disc installed.

2. Loosen the lock lever and adjust the table

angle until it is perfectly perpendicular.

3. Tighten the lock lever while holding the table

perpendicular.

4. Adjust the stop bolt and tighten. Note—

Remove this bolt if you want to have the table

angle less than 90˚.

5. Move the table angle and return it to the 0˚

point using the indicator, then recheck with

the square to verify the setting.

Figure 3. Squaring disc table.

This section will cover the basic adjustment

instructions needed to begin operation. Complete

the adjustments provided in this manual and then

read the remaining portion of the manual before

attempting any type of operation.

Your safety is important! Please follow the

warnings below during this entire section:

Loose hair and clothing

could get caught in

machinery and cause

serious personal injury.

Keep loose clothing

rolled up and long hair

tied up and away from

machinery.

Serious personal injury

could occur if you con-

nect your machine to the

power source before you

have completed the

assembly process. DO

NOT connect the

machine to the power

source until instructed to

do so.

Sharp edges on metal

parts may cause person-

al injury. Examine the

edges of all metal parts

before handling.

Tilt Indicator

Table Tilt

SECTION 6: ADJUSTMENTS

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 26 27

Comments to this Manuals

No comments