Grizzly G0554 User Manual download pdf (Page 38)

-36-

G0554 Gear-Head Floor Lathe





Figure 51. Feed direction and A/B feed/lead

selector.

A/B Feed/Lead Selector

Feed

Direction

Selector

2a. Push the power

feed lever shown in Figure

52 to the left

and down to engage the cross

feed.

2b. Pull the power feed lever to the right and up

to

engage the longitudinal feed.

3. Return

the lever to the center position to stop

the power feed.

Figure 52. Power feed lever settings.

Cross Feed

Longitudinal Feed

Power Feed

The carriage has longitudinal and cross slide

power feed capabilities.

To engage the power feed:

1. Move the feed direction lever to the desired

setting. The arrow above the screw thread

icon

indicates the direction of longitudinal

feed. Cross feed directions are as follows:

when the arrow points to the left, the cross

feed

is away from the spindle axis; when

arrow

points to the right, the cross feed is

towards the spindle axis (see Figure 51).

Note: These

instructions are valid with a

counterclockwise rotation of the spindle. All

directions reverse when spindle rotation is

reversed.

NOTICE

Feed rate is based on spindle RPM. High

feed rates combined with high spindle

speeds result in a rapidly moving carriage or

cross slide. Pay close attention to the feed

rate you have chosen and keep your hand

poised over the ON/OFF switch. Failure to

fully understand this will cause the carriage

to crash into the spindle.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 91 92

Comments to this Manuals

No comments