Grizzly G1037 User Manual download pdf (Page 16)

-14- G1037 Planer / Moulder

2. Mount the stamped steel ''L'' bracket supplied

with the moulder to the headstock and posi-

tion it laterally to correspond with the location

of the fence directly below it. Insert each knife

to full depth

in the cutterhead and slide it side-

ways until it just touches the 'L' bracket.

Lightly tighten the setscrews in the gib just

enough to keep the knife from moving in the

cutterhead. Install the other knives in the

same manner. Now tighten the gibs in 4-5

stages to assure that the clamping pressures

are evenly distributed through all the gibs. Do

not over tighten the setscrews to prevent

stripping the threads in the gibs.

Moulding Knives

Moulding cutter knives fit directly into the center

of each cutterhead slot and can be used with the

planer blades so that you can actually plane and

mould in one pass.

The Planer/Moulder accepts two thicknesses of

cutters:

1

⁄8

'' and

1

⁄4

''. For the

1

⁄8

'' cutter thickness,

only loosen the gib, using a piece of aluminum or

brass to tap down the wedge piece. For

1

⁄4

'' thick-

ness, remove the gib and the wedge piece and

replace with the special gibs for the

1

⁄4'' thickness.

These gibs are supplied with each set of mould-

ing knives.

WARNING: Always unplug the Planer/Moulder

from its power source before changing knives

and moulding cutters.

1. To Remove the wedge piece, loosen the gib

screws in the center gib using an Allen

wrench. Use the included brass punch and

tap the gib down into the cutterhead slot.

Figure 13. The wedge will then be loose and

can be removed. Figure 14. The gibs can

also be moved so the moulding cutters can be

installed on either end of the cutterhead.

Figure 13.

Figure 14.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments