Grizzly G1148 User Manual download pdf (Page 12)

G1148 15" Bandsaw

G1148 15" Bandsaw -12-

Bandsaw Table

5. Adjust the V-Belt tension by sliding the

motor along the slots. Proper tension is

achieved when the belt can be deflected

approximately

3

/4" with moderate finger

pressure.

6. Tighten the carriage bolts securely. Re-

check belt tension and pulley alignment.

The bandsaw table (#70) secures to the trunnions

(#74). The trunnions mount to the table support

bracket (#74) and the table support bracket

anchors to the bandsaw unit. The trunnions are

pre-mounted to the table. To mount the bandsaw

table:

1. Remove the two table bracket mounting

bolts (#78) from the bandsaw body. Figure

5 shows them removed.

2. There are two alignment pins (#50) that

cross diagonally between the bracket

mounting bolts. See Figure 5. Place the

table bracket on the body over the align-

ment pins and secure it to the bandsaw with

the two bolts.

Figure 5. Alignment pins and mounting holes.

Positive Stop

Adjusting Stud

Alignment Pins

Table Bracket

Mounting Holes

3. Remove the two star knobs (#77), table

insert (#68), and tapered pin (#71) from the

table.

4. Slip the table past the blade through the

table slot, rotate the table 90°, and set the

table trunnions onto the bracket. Make sure

the trunnion bolts (#72) drop through the

support bracket. See Figure 6.

5. Secure the table to the support bracket by

tightening the two star knobs onto the trun-

nion bolts. Remember to position the table

so that the miter slot is to the right of the

blade as you face the front of the bandsaw.

6. Place the table insert in the table top and

slide the tapered pin so it fits snugly in the

hole on the side of the table. Do not use

excessive force or the table will warp.

IMPORTANT: The tapered table pin must be in

position when operating the bandsaw.

Figure 6. Trunnion assembly.

Trunnion

Angle Pointer

Trunnion Bolt

DO NOT attempt to operate this machine

before completing the assembly and

adjustment instructions. Be sure that the

switch is off and the cord is disconnected

from the power source at all times until

assembly and adjustment are complete

and you have reviewed all safety guide-

lines. Serious injury could occur.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments