Grizzly G1006 User Manual download pdf (Page 20)

-20-

V-Belts

Inspect regularly for tension and wear. Replace

when necessary with a size B-42 belt for the spin-

dle pulley to the idler pulley belt and a size B-34

belt from the idler pulley to the motor pulley belt.

Check pulleys to ensure that they are properly

aligned.

Lubrication

Points requiring periodic lubrication are:

1. The main column. A light film of oil will

smooth action and prevent rust and corro-

sion.

2. The quill. A light coating of oil will ensure

smooth movement.

3. The quill return spring. Oil annually with a

light lubricant (SAE 20). Apply with a brush

or squirt can.

4. The quill pinion. Lubricate every 90 days

with non-hardening grease.

5. The table leadscrews. Lubricate once each

week with several drops of SAE 20.

6. The table leadscrew bearings. Lubricate

the bearings located at the ends of the table

and just in front of the Y axis hand crank on

a daily basis. You will find oil ports with a

ball. Apply a small amount of SAE 20 using

the oil can’s tip to push in the ball.

7. The table and apron slides. Lubricate the

table slides daily. An oil port with a ball is

located on the operators side of the table

edge. The apron slide can be oiled directly.

Make sure to carefully clean chips and dirt

off of this slide before oiling.

DO NOT make adjustments while the

Mill/Drill is running. Ensure that the switch

is off, power is disconnected and moving

parts have stopped before making adjust-

ments.

The internal quill pin is a setscrew and has

been pre-adjusted at the factory. It should not

need adjustment under normal circum-

stances.

The slotted setscrew on the left side of the head

is used for limiting the amount of rotational play

in the quill body. Loosening the check-nut and

tightening the setscrew will work to eliminate this

play in the quill.

If you are worried that you might have exces-

sive quill play, spindle looseness or if an acci-

dent has occurred that requires this

setscrew’s readjustment, contact the Service

Department for advice.

Quill

G1006/G1007 Mill/Drill

1 2 ... 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments

Grizzly G1006 User Manual Page 20

Comments to this Manuals

Related products and manuals for Tools Grizzly G1006