Grizzly G1037 User Manual download pdf (Page 13)

G1037 Planer / Moulder -11-

Figure 7.

Knife Removal

Unplug your Planer/Moulder from its power

source.

WARNING: Always unplug your planer from its

power source before changing knives and mould-

ing cutters.

Your planer knives are held in position by wedge-

type gibs. The setscrews press against the bot-

tom of the cutterhead slot, forcing the gib and

planer knife into a wedge-type seal. To break this

seal and remove the knife:

1. Simply loosen the gib setscrews and tap the

gib down using a hammer and the included

brass punch or a piece of wood. Figure 7.

2. Once the gib is free, remove the knife first and

then the gib.

3. Mark the gib and matching slot to be sure that

the gib is replaced in its original position.

4. Clean the knife and cutterhead slot to remove

all pitch and gum residue.

5. Repeat this procedure for the other two

knives.

SECTION 5: ADJUSTMENTS

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

No comments

Grizzly G1037 User Manual Page 13