Grizzly G0456 User Manual download pdf (Page 37)

G0456 Variable Speed Wood Lathe

-35-

When the table tilt is set to 0˚, the table should be

adjusted perpendicular to the sanding disc face.

Tools Needed Qty

Try-Square or Machinist's Square .....................

To adjust table tilt:

1. Using a try-square or machinist’s square,

set one edge on the table surface and the

other against the face of the disc as shown in

Figure 51. Note: This can be done with the

sandpaper installed, although it is somewhat

easier to measure if the disc does not have

the sandpaper disc installed.

Figure 51. Squaring table to disc.

Table Tilt

Figure 52. Adjusting table tilt indicator.

2. Loosen the lock lever, adjust the table angle

square with the disc, and tighten the lock

lever.

3. Adjust the indicator line over the 0° mark by

loosening/tightening the mounting screw, as

shown in

Figure 52.

The table must be aligned to the face of the

sanding disc so that the sandpaper does not rub

against the table.

To align the table:

1. Loosen the table mount bolts (Figure 53)

that secure the table to the table support

bracket.

Aligning Table

Figure 53. Table mount bolts.

Table

Mount

Bolts

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

No comments

Grizzly G0456 User Manual Page 37