Grizzly G0456 User Manual download pdf (Page 38)

-36-

G0456 Variable Speed Wood Lathe

Figure 54. Table aligned with sanding disc.

⁄16" Gap

2. Align the table so that there is approximately

⁄16'' gap between the 12" disc and the table

(Figure 54).

3. Tighten the bolts loosened in Step 1.

4. Spin the disc by hand to check if the sandpa-

per touches the table.

Note: DO NOT turn the disc sander ON at

this point.

5. Repeat Steps 1-3 if sandpaper touches the

table at any point in the rotation.

The miter gauge needs to be adjusted perpendic-

ular to the face of the wheel when it is mounted

in the table slot.

Tools Needed Qty

Try-Square or Machinist's Square .....................

To adjust miter gauge:

1. Use a try-square or machinist’s square with

one edge against the face of the miter gauge

and the other against the disc face as shown

in Figure 55.

Figure 55. Squaring miter gauge to disc.

Miter Gauge

2. Loosen the adjusting screw on the miter

gauge and adjust it flush with the edge of the

square.

3. Tighten the gauge adjusting screw, and verify

the setting.

Note: Sometimes the tightening procedure

can affect the adjustment.

4. Loosen the screw that secures the angle

pointer and adjust the pointer to the 0˚ mark.

5. Retighten the screw that secures the angle

pointer.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

No comments

Grizzly G0456 User Manual Page 38