Grizzly 12" Jointer w/spiral cutterhead manual insert User Manual download pdf (Page 37)

-22-

G0609 12" Parallelogram Jointer

• Remove foreign objects from the stock.

Make sure that any stock you process with

the jointer is clean and free of any dirt,

nails, staples, tiny rocks or any other foreign

objects that may damage the jointer blades.

• Only process natural wood fiber through

your jointer. Never joint MDF, particle board,

plywood, laminates or other synthetically

made materials.

• Make sure all stock is sufficiently dried

before jointing. Wood with a moisture con

tent over 20% will cause unnecessary wear

on the knives and poor cutting results.

• Make sure your workpiece exceeds

the minimum dimension requirements

(Figures 20 & 21) before edge jointing or

surface planing, or it may break or kick

back during the operation!

Figure 20. Minimum dimensions for edge

jointing.

Figure 21. Minimum dimensions for surface

planing.

⁄2" Min.

1" Min.

10" Min.







Squaring stock involves four steps performed

in the order below:

1. Surface Plane On The Jointer—The con

cave face of the workpiece is surface planed flat

with the jointer.

Previously

Jointed Edge

Previously

Surface

Planed Face

2. Surface Plane On a Thickness Planer—The

opposite face of the workpiece is surface planed

flat with a thickness planer.

3. Edge Joint On The Jointer—The concave

edge of the workpiece is jointed flat with the

jointer.

4. Rip Cut On A Table Saw—The jointed edge

of the workpiece is placed against a table saw

fence and the opposite edge cut off.

Squaring Stock

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 72 73

Comments to this Manuals

No comments

Grizzly 12" Jointer w/spiral cutterhead manual insert User Manual Page 37

Comments to this Manuals

Related products and manuals for Tools Grizzly 12" Jointer w/spiral cutterhead manual insert