Grizzly G4186Z User Manual download pdf (Page 16)

-14- G4186Z 18" Bandsaw

Controls

SECTION 5: ADJUSTMENTS

Do not make adjustments while the band-

saw is running. Ensure that the switch is

off, power is disconnected, and moving

parts have stopped before making adjust-

ments. Check adjustments while power is

still disconnected by manually turning the

bandsaw wheel by hand. Serious personal

injury may occur if this warning is ignored.

Figure 10. Controls from front of machine view.

General control and adjustment locations are

shown in Figures 10-12.

B

E

A

F

D

A

C

A. These two knobs allow the wheel cover

doors to be opened for access to the blade.

These doors must never be opened while the

machine is running.

B. This is the power ON/OFF switch.

C. This knob and handle lock the fence into

position.

D. These are the trunnion lock knobs. These

allow the table to be tilted 10˚ left and 45˚

right. Never attempt to loosen or tighten

these while the machine is running.

E. The miter gauge slides in the milled groove

in the table and can be set from 90˚ to 45˚ left

and right. Use the miter gauge for crosscut-

ting and miter-cutting.

F. This handwheel is used to control the blade

tension. Turning the wheel clockwise

increases the tension, while tuning counter-

clockwise decreases the tension.

Keep loose clothing out

of the way of machinery

and keep hair pulled

back.

Wear safety glasses dur-

ing the entire adjustment

process. Failure to com-

ply may result in serious

personal injury.

Disconnect power to the

machine when perform-

ing any adjustments or

maintenance. Failure to

do this may result in seri-

ous personal injury.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Comments to this Manuals

No comments