Grizzly G4186Z User Manual download pdf (Page 23)

G4186Z 18" Bandsaw -21-

Figure 22. Squaring table to blade.

Table

Table Insert

4. Secure the table by retightening the trun-

nion bolts. Recheck the table position to

ensure that unwanted shifting did not occur

during retightening.

The motor and motor mounting plate are already

assembled in the base of the saw. See Figure

23. In the event any disassembly of the bandsaw

is required, you may need to realign the motor

pulley and the lower wheel pulley.

Figure 23. Motor mounting plate.

Belt Tensioning

To perform the alignment:

1. Check for proper pulley alignment by plac-

ing a straightedge on the outside edge of

the upper pulley so that it overlaps the

motor pulley. If the straightedge does not

touch both pulleys evenly, the pulleys are

not aligned. Loosen one or both of the pul-

ley setscrews on their shafts and slide the

pulleys toward alignment. Remember to

retighten the setscrews when finished. See

Figure 24.

Disconnect power to the

machine when perform-

ing any adjustments or

maintenance. Failure to

do this may result in seri-

ous personal injury.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 47 48

No comments

Grizzly G4186Z User Manual Page 23