Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
This section will cover the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provid-
ed in this manual and then read the remaining
portion of the manual before attempting any type
of operation.
Your safety is important! Please follow the
warnings below during this entire section:
Base Feet
To attach the base feet to the bandsaw:
1. Remove the four knob bolts from the side
cover (Figure 5).
2. Attach the base feet to the bottom of the
bandsaw with the M8-1.25 x 25 hex bolts and
the M8-1.25 hex nuts (Figure 6). Note—The
hex bolts extend up through the bottom of
the feet, and through the bottom of the band-
saw, where they are secured with the hex
nut.
Figure 5. Removing the side cover knob bolts.
Figure 6. Base foot attached to the bandsaw.
Comments to this Manuals