Grizzly G8976 User Manual download pdf (Page 8)

-6-

G8976 3 Wheel 12" Bandsaw

SECTION 3: CIRCUIT REQUIREMENTS

Amperage Draw

The Model G8976 motor is wired to operate at

110V and will draw the following load:

Motor Load ..........................................4.5 Amps

Plug Type

The Model G8976 is supplied with a NEMA 5-15

plug. DO NOT modify the plug or power cord in

any way. See Figure 1 for a NEMA 5-15 plug and

grounded outlet.

Circuit Breaker Requirements

We recommend that the circuit you use your

machine on should be dedicated. Because the

machine motors are different sizes, please use

the following guidelines when choosing a circuit

breaker for your machine (circuit breakers rated

any higher are not adequate to protect the cir-

cuit):

Recommended Circuit Breaker ..............10 Amp

Your Circuit Capacity

Always check to see if the wires in your circuit are

capable of handling the amperage load from your

machine. If you are unsure, consult a qualified

electrician.

If you operate this machine on any circuit that is

already close to its capacity, it might blow a fuse

or trip a circuit breaker. However, if an unusual

load does not exist and a power failure still

occurs, contact a qualified electrician or our

Service Department at (570) 546-9663.

Serious personal injury could occur if you

connect your machine to the power source

before you have completed the assembly

process. DO NOT connect the machine to

the power source until instructed to do so.

Figure 1. NEMA 5-15 plug and

grounded outlet.

110 Volt

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

No comments

Grizzly G8976 User Manual Page 8