Grizzly G7945 User Manual download pdf (Page 22)

-20-

G7945/G7946 Radial Drill Press

Test Run

Wear safety glasses

whenever starting or

using machine. Failure

to comply may result in

serious personal injury.

Keep loose clothing

rolled up and out of the

way of machinery and

keep hair pulled back.

Once assembly is complete, you are ready to test

run the drill press.

To test run the drill press:

Turn the power supply ON at the main

panel.

2. With your finger poised on the paddle

switch (in case there is a problem), flip the

START button

ON. The drill press should run

smoothly, with little or no vibration or rubbing

noises.

Investigate and correct for strange or unusual

noises before operating the machine further.

If you cannot easily locate the source of a

potential problem, refer to

Troubleshooting

on Page 33. If you still can't solve the

problem, contact our Technical Support at

(570) 546-9663.

The Model G7945 should be secured to a bench.

The Model G7946 base should be secured to the

floor.

Bench Mounting

Components and Hardware Needed: Qty

Assembled Drill Press ........................................

⁄2" Mounting Hardware (Not Included) .......Varies

To mount the G7945 drill press to a table:

Clamp the base on a bench top capable

of holding approximately 100 lbs. plus the

weight of the workpiece using two clamps

Make sure the surface is flat and stable.

2. Using holes in the base as a guide (Figure

15), drill and bolt the base to the bench top

using

⁄2" lag bolts, or hex bolts, flat washers,

and hex nuts.

Mounting

Figure 15. Using holes as a drilling guide.

Mounting

Holes

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Comments to this Manuals

No comments

Grizzly G7945 User Manual Page 22

Comments to this Manuals

Related products and manuals for Tools Grizzly G7945