Grizzly G7945 User Manual download pdf (Page 30)

-28-

G7945/G7946 Radial Drill Press

Figure 24. Locating pin and nut (G7946).

2. Loosen the lock bolt (Figure 25) using the

included wrench

and tilt the table (G7945)

or the column support arm (G7946) to the

desired angle

.

Locating Pin Nut

Figure 26. Adjusting distance from column.

Figure 25. Angle adjustment bolt (G7945).

Clamp

Bolts

Table Rotation

(Note: The following steps only apply to the

G7946.)

1. Loosen the clamp bolt located under the table

26. Rotate the table the desired amount.

2. Always lock the table support arm in place

before operating the machine.

Distance from Column

(Note: The following steps only apply to the

G7946.

)

1. Loosen the clamp bolt located at the pivoting

elbow of the table support (

Figure 26).

2. Swing the table support to the desired dis-

tance from the column. The support bracket

may need to be rotated around the column

to keep the table centered under the chuck.

Secure all clamp bolts before operating the

machine.

3. Lock in place by tightening the lock bolt.

4. To return the table to its original position,

align the holes in the column support arm and

the table bracket, insert the locating pin and

nut, and gently tap the pin with a hammer.

5. Tighten the nut.

Lock Bolt

Table Tilt

With the Model G7946, start at Step 1. With the

Model G7945 start at Step 2

.

1. Turn the locating pin nut (Figure 24), in a

clockwise direction

.

This will draw the locat

-

ing pin out of the casting. Once loose, pull out

the pin and nut, and set them in a safe place

until needed.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Comments to this Manuals

No comments