Grizzly G7945 User Manual download pdf (Page 24)

-22-

G7945/G7946 Radial Drill Press

For your convenience, the adjustments listed

below have been performed at the factory; how

ever, because of the many variables involved

with shipping, we recommend that you at least

verify the following adjustments before operating

your machine—this will ensure that you know the

operating tolerances of your machine, and you

have them adjusted to your expectation.

Step-by-step instructions for these adjustments

can be found in SECTION 7: SERVICE

Factory adjustments that should be verified:

1. Depth Stop Calibration (Page 35)

2. Feed Shaft Spring Tension (Page 35)

Recommended

Adjustments

Note: Use 2" to 2

⁄4" long hex bolts.

7. Place the drill press on the base plate.

8. Position the drill press close to the front of the

mobile base, so the mobile base will not be a

tripping hazard.

9. Mount the drill press to the base plate with

lag bolts and flat washers (

Figure 18); or with

through bolts, flat washers, and hex nuts.

Figure 18. Drill press mounted on mobile base,

using a base plate for support.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 51 52

No comments

Grizzly G7945 User Manual Page 24