Grizzly 12" Jointer w/spiral cutterhead manual insert User Manual download pdf (Page 32)

G0609 12" Parallelogram Jointer

-17-

Pedestal Switch

The pedestal switch is upside down for shipping

purposes.

Components and Hardware Needed: Qty

• Flat Washers 10mm (Pedestal) ..................

• Lock Washers 10mm (Pedestal) ................

• Cap Screws M10-1.5 x 25 (Pedestal) ........

• Pedestal Switch .......................................... 1

To set up the pedestal switch:

1. Remove the M10-1.5 x 25 cap screws and

flat washers shown in

Figure 11.

2. Turn the pedestal upright and fasten it to

the jointer with the cap screws and washers

removed in Step 1, as shown in

Figure 12.

Figure 11. Location of pedestal mounting

hardware (one side shown).

Winding Cutterhead

Guard

Though the cutterhead guard is pre-installed, you

should check to make sure it works.

1. Pull the guard back and let it go. The guard

should spring back over the cutterhead.

— If the guard drags across the table, loosen

the set screws on the guard, raise it slight

ly, then tighten the set screws.

— If the guard does not spring back over the

cutterhead, loosen the set screws on the

jointer shown in Figure 10, hold the guard

over the cutterhead, and wind the shaft

collar clockwise. Tighten the set screws.

Check to see if the guard works and adjust

the collar as needed.

Figure 10. Loosening set screws.

Figure 12. Mounting pedestal in upright position.

Set

Screws

Shaft

Collar

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 72 73

No comments

Grizzly 12" Jointer w/spiral cutterhead manual insert User Manual Page 32