Grizzly 12" Jointer w/spiral cutterhead manual insert User Manual download pdf (Page 55)

-40-

G0609 12" Parallelogram Jointer













Figure 53. Using feeler gauges to set outfeed

table height.

5. Place the straightedge on the outfeed table

so it hangs over the cutterhead, and lower

the outfeed table until the straightedge is

0.062" (

⁄16") above the cutterhead body, as

determined by using the feeler gauges (see

Figure 53).

The infeed table on the Model G0609 has

positive stop bolts that, when properly set up,

allow the operator to quickly adjust the infeed

table between finish/final cuts and shaping/heavy

cuts.

We recommend setting the minimum depth of cut

⁄32" and the maximum depth of cut to

⁄8" for

most operations. DO NOT exceed

⁄8" cut per

pass on this machine or kickback and serious

injury may occur!

Each positive stop bolt (Figure 54) controls the

top or bottom range of the table movement. The

jam nuts lock the positive stop bolts in position so

they won't move during operation.

Setting Infeed Table

Figure 54. Positive stop bolts for infeed table.

Top Height

Bottom

Height

6. Tighten the outfeed table lock located at the

front of the machine, and tighten the positive

stop bolts and jam nuts located at the back of

the machine (see

Figure 47).

7. Set the knife heights (Page 34) to the new

outfeed table height.

Jam Nut

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 72 73

Comments to this Manuals

No comments

Grizzly 12" Jointer w/spiral cutterhead manual insert User Manual Page 55

Comments to this Manuals

Related products and manuals for Tools Grizzly 12" Jointer w/spiral cutterhead manual insert