Grizzly G0605X User Manual download pdf (Page 28)

-26-

G0605X/G0606X Extreme Series 12" Table Saw

The adjustments listed below have been per-

formed at the factory and no further setup is

required to operate the machine.

However, because of the many variables involved

with shipping, we recommend checking the fol

lowing adjustments to ensure the best possible

results from your new machine:

Recommended adjustment checklist:

• Blade Tilt

Stops on Page 49

• Miter Slot to Blade Parallelism on

Page 51

Recommended

Adjustments

Dust Collection

DO NOT operate the Model G0605X/G0606X

without an adequate dust collection system.

This saw creates substantial amounts of

wood dust while operating. Failure to use a

dust collection system can result in short

and long-term respiratory illness.

Test Run

Once the assembly is complete, test run your

machine to make sure it runs properly.

The Model G0605X/G0606X is operated by an

ON/OFF push button switch equipped with a

STOP paddle and a safety pin for disabling the

switch, as shown in Figure 31.

If, during the test run, you cannot easily locate

the source of an unusual noise or vibration, stop

using the machine immediately, then review the

Troubleshooting on Page 45.

If you still cannot remedy a problem, contact our

Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1. Read this manual and make sure you under-

stand SECTION 1: SAFETY on Page 7.

2. Review CIRCUIT REQUIREMENTS on Page

12, and make any necessary changes.

3. Make sure the blade guard and splitter (or

riving knife) are installed and correctly adjust

ed.

Components and Hardware Needed: Qty

4" Dust Hose (not included) ...............................1

4" Hose Clamp (not included) ............................

Dust Collection System (not included) ...............

Recommended CFM at Dust Port: 400 CFM

Do not confuse this CFM recommendation with

the rating of the dust collector. To determine the

CFM at the dust port, you must take into account

many variables, including the CFM rating of the

dust collector, the length of hose between the

dust collector and the machine, the amount of

branches or wyes, and the amount of other open

lines throughout the system. Explaining this cal

culation is beyond the scope of this manual. If you

are unsure of your system, consult an expert or

purchase a good dust collection "how-to" book.

To connect a dust collection hose:

1. Fit the 4" dust hose over the dust port, as

shown in

Figure 35, and secure in place with

a hose clamp

2. Tug the hose to make sure it does not come

off. Note: A tight fit is necessary for proper

performance.

Figure 35. Dust hose attached to dust port.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 28

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X