Grizzly G0605X User Manual download pdf (Page 41)

G0605X/G0606X Extreme Series 12" Table Saw

-39-

Figure 55. Clamping the resawing barrier.

4. Secure the joint with the wood screws.

Auxiliary Fence

The auxiliary fence is necessary if you are

resawing a workpiece that is taller than it is wide.

It should be no less than

⁄2" shorter than the

board to be resawn.

Components Needed for the Auxiliary Fence:

Hardwood or Plywood

⁄4" x (Height) x 40

⁄4" ......1

Flat Head Screws M8-1.25 x 25 (Not included) .4

Hex Nuts M8-1.25 (Included) .............................

Tools Needed for the Resaw Barrier:

Table Saw ..........................................................

Jointer and Planer .......................

Recommended

Clamps ............................................... 2 Minimum

Drill and Drill Bits ................................................

To build the auxiliary fence:

1. Cut a

⁄4" thick board 40

⁄4" long, and cut a

height no less than

⁄2" shorter than the board

to be resawn.

If you are using hardwood, cut

the board oversize, then joint and plane the

board to the correct size to make sure the

board is square and flat.

Note: Only use furniture grade plywood or

kiln dried hardwood to prevent warping.

2. Pre-drill and countersink four holes 1

⁄4" from

the bottom of the

board.

3. Glue the end of the 3" board, then clamp the

boards at a 90° angle with the larger board in

the vertical position as shown in

Figure 55.

3. Pull an end cap off of the standard fence,

then remove four hex nuts, flat washers, hex

bolts and one side of the fence facing from

the fence body.

4. Thread the flat head screws through the

auxiliary fence and into the hex nuts in the

standard fence body, and tighten securely as

shown in

Figure 56.

Figure 56. Auxiliary fence.













Resawing Operations

The table saw motor is pushed to its limits when

resawing. If the motor starts to bog down, slow

down your feed rate. Motor overloading and blade

wear can be reduced by using a ripping blade.

Ripping blades are designed to clear the sawdust

quickly.

Components Needed for Resawing:

Zero Clearance Insert .........................................1

Ripping Blade 12" ...............................................1

Clamps ...............................................................2

Shop Made Auxiliary Fence ...............................1

Shop Made Resaw Barrier .................................

You may experie

nce kickback during this

procedure. Stand to the side of the blade

and wear a full face shield to prevent injury

when resawing.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 41

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X