Grizzly G0605X User Manual download pdf (Page 51)

G0605X/G0606X Extreme Series 12" Table Saw

-49-

Blade Tilt Stops

The table saw features stop bolts that stop the

blade exactly at 45° and 90° during blade adjust

ments.

The stops have been set at the factory and

should require no adjustments. However, we still

recommend that you verify the settings.

Tools Needed Qty

90° Square ........................................................ 1

Combo Square ..................................................

Wrench 12mm ...................................................

Hex Wrench 4mm ..............................................

Hex Wrench 5mm ..............................................

To set the 90

° stop bolt:

1. DISCONNECT THE SAW FROM POWER!

2. Position the blade tilt to zero (see indicator

on the front of the saw), and raise the blade

several inches above the table.

3. Place a machinist’s square against the table

and blade so it contacts the blade evenly from

bottom to top. Make sure a blade tooth does

not obstruct the movement of the square.

—If the blade is 90° to the table when the

stop bolt contacts the underside of the

table, go to To Set the 45

° Stop Bolt.

—If the blade is not 90° to the table, you will

need to adjust the 90° stop bolt.

4. Tilt the blade to 20° to access the 90° stop

bolt under the table.

5. Open the motor access cover, loosen the jam

nut shown in

Figures 75 & 76, adjust the

stop bolt up or down, and repeat Steps 2-3

until the stop bolt contacts the table

when the

blade is at

0°.

Figure 76. 90° stop bolt and jam nut (table

removed for clarity).

90° Stop Bolt

& Jam Nut

6. Tighten the jam nut.

To set the 45° stop bolt:

1. Repeat Steps 1-3 from the previous set of

steps using a combo square set to 45°.

—If the blade is 45° to the table when the

stop bolt contacts the cabinet, go to

Adjust the Tilt Indicator Arrow

—If the blade is not 45° to the table go to

Step 2

2. Remove the blade height lock knob and

handwheel.

3. Move the blade angle to 30°, or remove

the panel on the right side of the cabinet to

access the 45

° stop bolt.

Figure 75. 90° stop bolt and jam nut.

90° Stop Bolt

& Jam Nut

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 51

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X