Grizzly G0605X User Manual download pdf (Page 39)

G0605X/G0606X Extreme Series 12" Table Saw

-37-

To cut rabbets with the standard blade:

Note: Cutting rabbets with a standard saw blade

DOES NOT require the use of a sacrificial fence.

Note: Reduce motor overloading and blade wear

by using a ripping blade. Ripping blades are

designed to clear the sawdust quickly.

1. DISCONNECT THE SAW FROM POWER!

2. Ensure that the riving knife is installed.

3. Clearly mark the width of the rabbet cut on

the workpiece.

Note:

Include marks on the edge of the

workpiece to clearly identify the intended cut

while it is laying flat on the saw table.

4. Raise the blade up to the desired depth of cut

(depth of rabbet channel desired).

When cut-

ting deep rabbets,

take more than one pass

to reduce the risk of kickback.

Figure 52. Rabbet cutting with a standard blade.

Figure 53. Second cut to create a rabbet.

10. Adjust the saw blade height to intersect with

the first cut.

11. Perform the second cut to complete the rab-

bet.

6. Reconnect the saw to the power source and

turn the saw

ON.

7. When the blade has reached full speed, per-

form a test cut with a scrap piece of wood.

8. If the cut is satisfactory, repeat the cut with

the final workpiece.

9. Stand the workpiece on edge as shown in

Figure 53.

5. Adjust the fence so the blade is aligned with

the inside of your rabbet channel as shown in

Figure 52.

The danger of kickback increases relative to

the depth of a cut. Reduce the risk of kick

back by making multiple passes to achieve

the desired depth of cut. Failure to follow

these warnings could result in serious per

sonal injury.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 39

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X