Grizzly G0605X User Manual download pdf (Page 27)

G0605X/G0606X Extreme Series 12" Table Saw

-25-

Figure 31. Switch installed.

Figure 32. Miter gauge installed.

Washer

Handle

2. Slide the miter gauge into the miter gauge

slot to the left of the blade; or store it tempo

rarily on the brackets near the blade angle

handwheel.

Components and Hardware Needed: Qty

Miter Gauge

....................................................... 1

Miter Gauge Handle ..........................................

Flat Washer 8mm ..............................................

To install the miter gauge:

1. Install the miter gauge handle and 8mm flat

washer onto the miter gauge as shown in

Figure 32.

Miter Gauge

Fence Components

Components and Hardware Needed: Qty

Fence Knob

....................................................... 1

Fence Resting Brackets ....................................

Flange Bolts M8-1.25 x 12 .................................

To install the fence knobs, fence, and fence

resting brackets:

1. Install the fence knob as shown in Figure

33.

Figure 33. Fence knob installed.

2. Install the fence onto the table to the right of

the blade.

3. Install the fence resting brackets (Figure 34)

onto the cabinet under the Outfeed Table

with two flange bolts.

Figure 34. Fence resting brackets installed.

Brackets

Stop Paddle

Flange Bolt

Anti-Start

Safety Pin

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 75 76

No comments

Grizzly G0605X User Manual Page 27