Grizzly G0605X User Manual download pdf (Page 46)

-44-

G0605X/G0606X Extreme Series 12" Table Saw

Cleaning the Model G0605X/G0606X is relatively

easy. Vacuum excess wood chips and sawdust,

and wipe off the remaining dust with a dry cloth.

If any resin has built up, use a resin dissolving

cleaner to remove it. Treat all unpainted cast

iron and steel with a non-staining lubricant after

cleaning.

Occasionally it will become necessary to clean

the internal parts with more than a vacuum. To do

this, remove the table top and clean the internal

parts with citrus cleaner or mineral spirits and

a stiff wire brush or steel wool. DO NOT USE

WATER—WATER WILL CAUSE CAST IRON TO

RUST. Make sure the internal workings are dry

before using the saw again, so that wood dust

will not accumulate. If any essential lubrication

is removed during cleaning, re-lubricate those

areas.

Cleaning

SECTION 6: MAINTENANCE

Always disconnect power

to the machine before

performing maintenance.

Failure to do this may

result in serious person

-

al injury.

For optimum performance from your machine,

follow this maintenance schedule and refer to any

specific instructions given in this section.

Daily

• Check guard operation.

• Inspect blades for damage or wear.

• Check for loose mounting bolts/arbor nut.

• Check cords, plugs, and switch for damage.

• Any other condition that could hamper the

safe operation of this machine.

• Vacuum dust buildup from inside the cabinet

and off of the motor after use.

• Wipe the table clean after every use—this

ensures moisture from wood dust does not

remain on bare metal surfaces.

Weekly

• Wipe down the table surface and grooves

with a lubricant and rust preventive such as

SLIPIT

®

.

• Clean the pitch and resin from the saw blade

with a cleaner like OxiSolv

®

Blade & Bit

Cleaner.

Monthly

• Check the flat belt for damage or wear.

Schedule

Lubricate the areas indicated below every 6–12

months, depending on frequency of use. These

areas can be reached through the motor cover

opening or the blade opening. Check all adjust

-

ments after lubricating.

Lubricate the following components with

multi-purpose grease:

1. Trunnion and trunnion slide

(where Parts

13 and 42 slide each other, on

Page 61).

2. The worm gear, bevel gears, acme screw

and shafts

(Parts 99, 33, 38, 6, and 40 on

Page 61).

Note: Using a small brush to apply the grease

may be easier than using your fing

ers.

Lubrication

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 75 76

Comments to this Manuals

No comments