Grizzly G0605X User Manual download pdf (Page 48)

-46-

G0605X/G0606X Extreme Series 12" Table Saw

Table Saw Operations

Symptom Possible Cause Possible Solution

Machine has vibra-

tion or noisy opera

tion.

1. Motor or component is loose.

2. Flat belt worn or loose.

3. Motor fan is rubbing on fan cover.

4. Pulley is loose.

5. Machine sits unevenly on floor.

6. Arbor bearings are at fault.

7. Arbor pulley is loose.

8. Workpiece is loose.

9. Motor bearings are at fault.

10. Blade is at fault.

11. Loose arbor nut

12. Centrifugal switch (single-phase).

1. Inspect/replace stripped or damaged bolts/nuts, and

re-tighten with thread locking fluid.

2. Inspect/replace flat belt with new one (refer to

Page

47).

3. Replace dented fan cover; replace loose/damaged

fan.

4. Realign/replace shaft, pulley, set screw, and key as

required.

5. Relocate/shim machine.

6. Replace arbor housing bearings; replace arbor.

7. Retighten/replace arbor pulley with shaft and thread

locking liquid.

8. Use the correct holding fixture and reclamp

workpiece.

9. Test by rotating shaft; rotational grinding/loose shaft

requires bearing replacement.

10. Replace warped, bent, or twisted blade; resharpen

dull blade.

11. Tighten the arbor nut.

12. Replace centrifugal switch.

Symptom Possible Cause Possible Solution

Blade is not aligned

with miter slot or

fence.

1. Blade is warped.

2. Table top is not parallel to blade.

3. Fence is not parallel to blade.

1. Replace blade (

Page 22).

2. Make table parallel to blade (

Page 51).

3. Make fence parallel to blade (

Page 54).

Blade does not

reach 90°.

1. 90° stop bolt is out of adjustment.

2. Sawdust loaded up on positive stop.

1. Adjust 90° stop bolt (

Page 49).

2. Clean sawdust off positive stop.

Blade hits insert at

45°.

1. 45° stop bolt is out of adjustment.

2. Hole in insert is inadequate.

3. Table out of alignment.

4. Blade position is incorrect.

1. Adjust 45° stop bolt (

Page 49).

2. File or mill the hole in the insert.

3. Align blade to the table (

Page 51).

4. Adjust blade position.

Board binds or

burns when feeding

through tablesaw.

1. Dull blade.

2. Blade is warped.

3. Fence is not parallel to blade.

4. Table top is not parallel to blade.

1. Replace blade.

2. Replace blade (

Page 22).

3. Make fence parallel to blade (

Page 54).

4. Make table parallel to blade (

Page 51).

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 48

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X