Grizzly G0605X User Manual download pdf (Page 49)

G0605X/G0606X Extreme Series 12" Table Saw

-47-

Replacing Flat Belt

To ensure optimum power transmission from the

motor to the blade, the flat belt must be in good

condition. Replace the belt if it becomes cracked,

frayed, or glazed.

Tools Needed Qty

Arbor Wrenches ................................................

Hex Wrench 4mm ..............................................

Phillips Head Screwdriver .................................

Wood Block 12" Long 4x4 ...............................

Wrench or Socket

14mm ................................... 1

To remove the flat belt:

1. DISCONNECT THE SAW FROM POWER!

2. Raise the motor all the way up, tilt it to 0°,

and open the motor cover.

3. Loosen the three motor mounting hex nuts

shown in

Figure 70 two turns and place a

4x4 block between the cabinet and bottom of

the motor

Figure 72. Belt cover plate and top button head

cap screws.

Button Head

Cap Screws

Belt Cover Plate

Figure 70. Motor mounting bolts.

Mounting Bolts

and Nuts

4. Lower the arbor assembly until the motor

rests on the wood block as shown in

Figure

to reduce tension on the flat belt.

Be careful

not to damage the motor, and do not force

the arbor down further when it becomes dif

ficult to move the handwheel.

5. Tighten the motor mounting nuts to hold the

motor in place.

6. Raise the blade all the way up and remove

the wood block, table insert, blade guard and

splitter or riving knife, arbor nut, flange, and

the saw blade.

7. Tilt the arbor to 20°.

8. Remove the upper two button head cap

screws and spacers on the belt cover plate

shown in

Figure 72.

Figure 71. Motor resting on wood block.

Wood

Block

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 49

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X