Grizzly G0605X User Manual download pdf (Page 34)

-32-

G0605X/G0606X Extreme Series 12" Table Saw

"Crosscutting" means cutting across the grain of

the workpiece. In MDF or particleboard, cross

-

cutting means cutting across the width of the

workpiece.

To make a crosscut using the miter gauge:

1. DISCONNECT THE SAW FROM POWER!

2. Ensure that the blade guard and splitter or

riving knife is installed.

3. Move the rip fence aside and position the

miter gauge, adjusted to 90°, in a miter slot

.

4. Adjust the blade height so the teeth protrude

approximately

1

⁄4" above the workpiece.

5. Slide the miter gauge near the blade and

adjust the workpiece so the blade will cut on

the waste side of the line.

6. Plug in the tablesaw, turn it ON, and allow it

to reach full speed.

7. Hold the workpiece firmly against the face of

the miter gauge and ease it into the blade as

shown in

Figure 44.

Turn OFF the saw and allow the blade to

come to a complete stop before removing

the cut-off piece. Failure to follow this warn

-

ing could result in serious personal injury

Figure 44. Typical crosscutting operation.

Crosscutting

9. The jointed edge of the workpiece must slide

against the fence during the cutting opera

-

tion.

10. Use a push stick to feed the workpiece

through the saw blade, as shown in

Figure

43, until the workpiece is completely past the

saw blade.

Figure 43. Typical ripping operation.

Turn OFF the saw and allow the blade to

come to a complete stop before removing

the cut-off piece. Failure to follow this warn

-

ing could result in serious personal injury.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

Comments to this Manuals

No comments