Grizzly G0605X User Manual download pdf (Page 56)

-54-

G0605X/G0606X Extreme Series 12" Table Saw

Miter Gauge

Tools Needed Qty

Hex Wrench 2.5mm ...........................................

Phillips Head Screwdriver .................................

Machinist Square ...............................................

Adjustable Square .............................................

To adjust the miter gauge so it is perpendicu

lar to the saw blade:

1. Slide the miter gauge into the miter gauge

slot to the left of the blade.

Parallelism

Align the fence alongside the miter slot as shown

in Figure 86, and lock it down.

If the fence is not parallel to the miter slot:

1. Loosen the fence lock handle.

2. Remove the fence from the saw and adjust

the set screws on the rear side of the front

bracket shown in

Figure 85.

3. Make very minor adjustments and recheck

by reclamping the fence along the miter slot

after each adjustment. Keep in mind that a

small turn of the set screw can make a large

difference over the length of the fence. Be

sure clamping pressure is still adequate.

Figure 86. Example of fence aligned parallel to

miter slot.

5. Loosen the jam nut and adjust the stop screw

until it is seated against the shaft (see

Figure

87 for part locations), then tighten the jam

nut.

6 Loosen the screw on the front of the miter

bar, adjust the pointer to 0°, then tighten the

screw.

7. To adjust to 45°, follow Steps 1-5 using an

adjustable square set to 45°.

8. Double-check your adjustments at 45° and

90° to assure that you have accurately set

your miter gauge.

9. To fit the miter bar tighter in the miter slot,

turn the adjustment set screws shown in

Figure 87 clockwise in small increments, and

test fit between adjustments until the miter

gauge fits your expectations.

Figure 87. Miter gauge diagram.

Pointer

Jam Nut

Stop Screw

Shaft

Set

Screws

2. Push in the shaft (Figure 87).

3. Loosen the lock knob on the miter gauge and

place a square against the face of the miter

body and the blade.

4. Adjust the miter body until the pointer is at

0° and there is no space between the square

and the blade, then tighten the lock knob.

Lock Knob

Miter Body

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 75 76

Comments to this Manuals

No comments

Grizzly G0605X User Manual Page 56

Comments to this Manuals

Related products and manuals for Power saws Grizzly G0605X